- Introduction
- Operation
- Assumptions
- Conventions
- Additional Information
- Accessproes amd Ordering Information
- Warranty and Return Procedure Specifications
- Kepler Imaging System Overview
- Check Your Shipment
- Camera Care and Safety
- Instaling the FLI Software Installation Kit
- Confirming Driver Installation
- Third Party Software
- Setting Up and Powering Your System
- Sensor Temperature Information
- External Triggering
- Hardware
- Troubleshooting & Specifications
- Exposure & Triggering Guide
- Introduction
- Operation
- Assumptions
- Conventions
- Additional Information
- Accessproes amd Ordering Information
- Warranty and Return Procedure Specifications
- Kepler Imaging System Overview
- Check Your Shipment
- Camera Care and Safety
- Instaling the FLI Software Installation Kit
- Confirming Driver Installation
- Third Party Software
- Setting Up and Powering Your System
- Sensor Temperature Information
- External Triggering
- Hardware
- Troubleshooting and Specifications
- Exposure and Triggering Guide
Finger Lakes Instrumentation, a division of IDEX Health & Science LLC
1250 Rochester St.
Lima, New York 14485
1250 Rochester St.
Lima, New York 14485
Phone: 585-624-3760
Email: IHSKeplerSupport@IdexCorp.com
Web: www.flicamera.com
Email: IHSKeplerSupport@IdexCorp.com
Web: www.flicamera.com
©2023 IDEX Health & Science LLC
KL400 Shutter Assembly
If you need to service your shutter assembly or replace the shutter assembly please see the following schematic (Figure 1) to assist you. Please note that the shutter assemblies are very fragile.
Figure 1. Shutter Assembly
