Firmware Updates
Updating the firmware of a Kepler camera is a process that will likely be done multiple times in a cameras
lifetime. Firmware updates may contain stability or functional improvements. The process of updated a cameras
firmware is not difficult, however, there are important steps which must not be left out.

The software required to update the camera firmware is located on the FLICamera website under Support.
Download Kepler Camera Firmware Updater and extract the files. Assure that no other FLI programs are
running (such as FLI Pilot), then, run the application titled FLIP_Installer and complete the installation
procedure.

Prior to updating, a backup of the cameras current configurations should be created. This process is well
documented in Kepler - Saving and Reloading Camera Factory Settings.pdf, a document which is included
in the zip that contained the FLIP Installer.

When you have completed backing up the configurations and settings of the camera, follow the directions
included in Kepler - Firmware Update Instruction.pdf. If a problem occurs, Kepler - Saving and Reloading
Camera Factory Settings.pdf documents the procedure to properly reload settings onto a camera.
Phone: 585-624-3760
Email: IHSKeplerSupport@IdexCorp.com
Web: www.flicamera.com
Finger Lakes Instrumentation, a division of IDEX Health & Science LLC
1250 Rochester St.
Lima, New York 14485
©2023 IDEX Health & Science LLC