Control Panel

Control Panel

Grab Control

The Grab Control Panel is your direct connection to the camera. Important information regarding the device is

displayed, and commands for image capture are initiated here.

Imaging Parameters

The Imaging Parameters Panel contains almost every setting you would set before image capture is located

here. From the camera, to the sensor, to the filter wheel, any pre-photo setting is found within the tabs placed in

this panel.

Image Analysis

The Image Analysis Panel contains settings for post-capture procedures. Primarily: viewing images, and

viewing histograms and profiles of images.

Display Control

The Display Control Panel provides options for customizing the display of FLI Pilot, including orientations and

panel options. For small tweaks in FLI Pilot, head here.

Tool Settings and Sequencing

Tool Settings and Sequencing essentially allows you to setup and run a batch file. You are able to setup various

settings like different gains etc. to take successive images while you change the settings between images.

Execute uses the settings, then does a grab. Then it uses the next set of settings and does another grab.

Tester Routines

The Tester Routines tab includes a number of useful subroutines for the camera. These include the ability to

stack frames, run frame subtractions, and more.

Finger Lakes Instrumentation, a division of IDEX Health & Science LLC
1250 Rochester St.
Lima, New York 14485

Phone: 585-624-3760
Email: IHSKeplerSupport@IdexCorp.com
Web: www.flicamera.com